Subframe Connector Installation

This project shows how to install the Hotchkis sub-frame connectors in a convertible. I'm not going to go into a lot of detail about the installation as the Hotchiss site has done a very good job of that:
Hotchkis Installation Instructions
There is also a nice thread by JimM on the Team Camaro site that details his installation :
JimM's Sub-Frame Connector Installation
For my installation I put the car up on jackstands; the front at the front of the subframe, and the back at the rear axle. I was able to remove and replace the rear subframe bushings by slightly prying the subframe away from the body. You really only need an extra .5-1" to get at the bushings.
img/sfconn1.jpg